| Re: Новая трасса... по местам боевой... [сообщение #154774 является ответом на сообщение #154765] |
пн, 01 июля 2013 01:02   |
|
|
| ulet писал(а) вс, 30 июня 2013 23:44 |
Сапёр должен бояться. Только тогда он будет в безопасности. Бронежилет, если не специальный, для разминирования, внушает ложное чувство самоуверенности, но не является достаточной защитой. Всё что меньше 45мм рвёт руки, всё что больше рвёт бронежилет. Просто не надо таскать ВОПы на "выставки", а уничтожать на месте, благо, что местность там это позволяет. Перенос ВОПа это исключение, а не нормальная работа.
|
Ну а что такое специальный?
Вот тех. требования ООН к средствам защиты
4.3. Minimum PPE requirement
PPE shall be capable of protecting the parts of the body that are covered against the blast
effects of 240g of TNT at distances appropriate to the wearer’s activity.
The amount of PPE provided shall be determined as a result of a field risk assessment and
management decision. The minimum PPE inside the safety distance of a suspected hazardous
area or when engaged in any activity that involves being close to mines and ERW, shall be:
a) body armour capable of satisfying the ballistic test outlined in STANAG 2920,
achieving a V50 rating (dry) of 450m/s for 1.102g fragments. It shall also be capable
of protecting the chest, abdomen and groin area against the blast effects of 240gm
of TNT at 60 cm from the closest part of the body; and
b) eye protection that is held over the eyes in a frame that prevents blast ingress from IMAS 10.30
Second Edition
(01 April 2009)
3
beneath. The eye protection shall be capable of retaining integrity against the blast
effects of 240 gm of TNT at 60 cm and shall provide protection equivalent to not
less than 5mm of untreated polycarbonate. However, it is recommended that eye
protection should be a part of frontal head protection capable of protecting against
the blast effects of 240gm of TNT at 60 cm and providing full frontal coverage of
face and throat.
Тут они ссылаются на НАТОвский стандарт, наш ГОСТ на эту тему с похожими параметрами тоже есть.
И вот бронежилет, от отечественного производителя:
http://www.kirasa.ru/go.phtml?part=production&mod=armor& amp;prt=kirasa-d
Вполне соответствует.
Так что, наверное, давайте сойдемся на том, что бронежилет это правильно, но он должен отвечать требованиям.
|
|
|
|